[. . . ] Grasp the PC card and remove it.
Eject button
NOTE: Before removing any PCMCIA device, make sure it is "Stopped" in the PC Card Manager.
EXPANSION MEMORY REMOVAL
PALMREST REMOVAL
M2x6 black screws
Memory cover
M2x10 black screws
M2x4 flat head black screws 1. Push the memory clips outward and pull the memory module out of the connector on a 45 degree angle.
1. [. . . ] Remove the following screws: - Two M2x10 black screws - Four M2x6 black screws
Tough Enough for Today's World.
TOSHIBA
FIELD REPLACEABLE UNIT DOCUMENTATION
Portege 3400 Series
PALMREST REMOVAL MEMBRANE SWITCH REMOVAL
Membrane switch Palm rest cover Bracket
TM
Membrane switch cable
PJ320
3. Disconnect the membrane switch cable from PJ320 and remove the palm rest cover.
M2x3 flat head silver screws 1. Speaker ground plate
KEYBOARD REMOVAL
Keyboard AccuPoint cable PJ310 Keyboard cable
SPEAKER REMOVAL
PJ110 1. Lift out the speaker assembly and remove the speaker from the speaker holder.
Tough Enough for Today's World.
TOSHIBA
FIELD REPLACEABLE UNIT DOCUMENTATION
Portege 3400 Series
DISPLAY ASSEMBLY and UPPER COVER REMOVAL
Display assembly PJ300 Insulator LCD harness M2x8 black screws Make sure the insulator is tuck in under the top cover assy M2x6 black screws 1. - Three M2x8 black screws - Two M2x6 black screws M2x6 brass screws 3. Remove two M2x6 brass screws and two M2x4 brass screws securing the system board. Remove one M2x6 brass screw securing the latch hole assembly and remove the latch hole assembly. Peel off the glass tape securing the RTC battery harness and disconnect the RTC battery harness from PJ735. Lift out the system board.
Tough Enough for Today's World.
TOSHIBA
FIELD REPLACEABLE UNIT DOCUMENTATION
Portege 3400 Series
DISPLAY MASK REMOVAL
Latch
TM
FL INVERTER AND LCD REMOVAL
FL cable LCD cushions LCD module M2x4 Flat head brass screws FL inverter
Display mask
LCD mask seals 1. Remove two LCD cushions and two LCD mask seals using a pair of fine-tipped tweezers. [. . . ] Remove two LCD cushions and two LCD mask seals using a pair of fine-tipped tweezers. Carefully insert your fingers between the display mask and the LCD module and pry open the display mask.
LCD module
LCD cable
Fl inverter cable
1. [. . . ]